Oakland 10 Minute Water Heater Maintenance Check

Posted by on Feb 26, 2014 in Water Heater Repair Oakland

We are going to put you to work today, however only for about 10 minutes. Yep, that’s all it will consider these two vital water heater maintenance jobs; however, Water Heater Repair Oakland understands they will do an exceptional task of assisting with 3 things:

  1. Having your water heater last as long as possible (that will conserve you money).
  2. Seeing to it the water heater runs safely (we do not desire it to blow up).
  3. Having it run as energy efficiently as possible (likewise saving you money).

So with that in mind, are you all set to spend 10 minutes once or two times a year to assist in saving some money? Water Heater Repair Oakland CA thought so.

Testing the T&P Relief Valve

Frequently called the T&P Valve, or the temperature and pressure relief valve, has a crucial task. It assists see to it excess pressure does not build up inside the water tank, or in much more easy terms, it ensures the water heater does not explode. As the photo shows, it has a lever or little handle on it. All you need to do is raise it part way and then let go of it. Hopefully, it snapped back to its shut position rapidly. If it is working properly, a little water can be heard entering into the drain pipe below the lever you just lifted and you possibly heard some pressure being released. If none of these things have actually taken place during the test, the valve will require to be replaced.

As inspectapedia.com states: “dripping TP relief valves are unsafe. The hazard is that minerals in the water supply accumulate inside the valve during the passage of hot water through the valve assembly. That accumlation of scale will eventually block operation of the relief valve, causing the relief valve to fail to operate properly if unsafe pressure or temperature occurs in the water heater in the future. The risk, ultimately, is a water heater tank or heating boiler explosion.”  (read more…)

Perform a Mimi Water Heater Tank Flush

By nature, rust and deterioration will take place inside the water storage tank thanks to the chemical reactions taking place with all the components inside that are required to warm the water. We will not get too technical right here, however it is simple to help avoid this from happening by doing a flush or draining of all or a portion of the water in the tank.

For simply a mini flush, position a pail under the drain valve below the tank. Open the drain valve and fill the pail with water. Drain a minimum of a few gallons of water in all. Let the water sit in the container for a couple of minutes to settle and examine if there is much that settles to the bottom of the pail. If there is, if the water heater has not been drained for a long period of time (or ever), it would be best to do a full flush of the tank to get as much of the sediment out as possible. You will wish to turn the temperature dial down and could wish to let the water cool off for about an hour first so it is not too hot while draining it. Likewise, it would be easier to attach a hose to the drain valve and let the water go outside instead of making use of buckets.

If the water looks relatively clean and clear from the tiny test you should be all set. When the water heater has a large quantity of sediment inside of it, it can make loud popping noises and it cuts down on its effectiveness too.

Though water heaters are relatively maintenance free and easy to operate, whenever you feel the slightest uncomfortable or are uncertain of what to do, it is always best to have a plumbing professional assist with the situation.

Water Heater Repair Oakland